4gamers Pro4-10 Ear Pads
![Without Pads](ear-pads/pro4-10-without-ear-pad.jpg)
The Pro4-10 ear-pad cushions are approximately 70 mm in diameter with an integrated dust filter. It is a typical design where a seam goes over the edge of the front panels.
![Cushion Front](ear-pads/pro4-10-ear-pad-cushion-front.jpg)
![Front View](ear-pads/pro4-10-ear-pad-front-view.jpg)
![Back Seam](ear-pads/pro4-10-ear-pad-back-seam.jpg)
![Seam View](ear-pads/pro4-10-ear-pad-seam-view.jpg)
![Front Panel](ear-pads/pro4-10-front-panel.jpg)
![Installed View](ear-pads/pro4-10-ear-pad-installed-view.jpg)
In my case, I had disassembled the headphones for cleaning and therefore was able to install it in this way, in advance, which was much easier. Consequently, it is much clearer to see in the photograph how the seams go over the edge of the front panel.
![View of Seam](ear-pads/pro4-10-view-of-seam.jpg)
![Installed](ear-pads/pro4-10-ear-pad-installed.jpg)
This Article Continues...
4gamers Pro4-10Wire Repair
Ear Pads
Driver
Microphone
Volume Control
Headband
Disassembly